Graphics, sound and multimedia • Re: PeppyMeter not working

Code:

[current]meter = randomrandom.meter.interval = 20meter.size = widescreen.width = 1280screen.height = 400exit.on.touch = Falsestop.display.on.touch = Falseoutput.display = Trueoutput.serial = Falseoutput.i2c = Falseoutput.pwm = Falseoutput.http = Falseuse.logging = Trueuse.cache = Trueframe.rate = 30

Code:

# For more options and information see# http://www.raspberrypi.org/documentation/configuration/config-txt.md# Some settings may impact device functionality. See link above for details# uncomment if you get no picture on HDMI for a default "safe" mode#hdmi_safe=1# uncomment this if your display has a black border of unused pixels visible# and your display can output without overscan#disable_overscan=1# uncomment the following to adjust overscan. Use positive numbers if console# goes off screen, and negative if there is too much border#overscan_left=16#overscan_right=16#overscan_top=16#overscan_bottom=16# uncomment to force a console size. By default it will be display's size minus# overscan.#framebuffer_width=1280#framebuffer_height=720# uncomment if hdmi display is not detected and composite is being outputhdmi_force_hotplug=1# uncomment to force a specific HDMI mode (this will force VGA)#hdmi_group=1#hdmi_mode=1# uncomment to force a HDMI mode rather than DVI. This can make audio work in# DMT (computer monitor) modes#hdmi_drive=2# uncomment to increase signal to HDMI, if you have interference, blanking, or# no display#config_hdmi_boost=4# uncomment for composite PAL#sdtv_mode=2#uncomment to overclock the arm. 700 MHz is the default.#arm_freq=800# Uncomment some or all of these to enable the optional hardware interfacesdtparam=i2c_arm=on#dtparam=i2s=ondtparam=spi=onenable_uart=1# Uncomment this to enable the lirc-rpi module#dtoverlay=lirc-rpi# Additional overlays and parameters are documented /boot/overlays/README# Enable audio (loads snd_bcm2835)dtparam=audio=onhdmi_group=2hdmi_mode=1hdmi_mode=87hdmi_cvt 800 480 60 6 0 0 0dtoverlay=ads7846,cs=1,penirq=25,penirq_pull=2,speed=50000,keep_vref_on=0,swapxy=0,pmax=255,xohms=150,xmin=200,xmax=3900,ymin=200,ymax=3900hdmi_drive=1hdmi_force_hotplug=1#max_usb_current=1hdmi_timings=400 0 100 10 140 1280 10 20 20 2 0 0 0 60 0 43000000 3