Hi, thanks for your response. I used locally bought in my country pca module https://allegro.pl/oferta/modul-pca9685 ... 3171302810
I tried to control pca board with only one servo connected to 0 port with adafruit blinka and adafruit servokit libraries. Both installed into os without venv, since venv caused problem to my camera access used in the same project, thus i decided to control everything without venv and bypass extrimely managed repo warning with parameter to pip. Forgot to mention this fact, but it is probably can also matters.
Thanks a lot for your references, I'll take a look into them a bit later, since it's already late here.
I tried to control pca board with only one servo connected to 0 port with adafruit blinka and adafruit servokit libraries. Both installed into os without venv, since venv caused problem to my camera access used in the same project, thus i decided to control everything without venv and bypass extrimely managed repo warning with parameter to pip. Forgot to mention this fact, but it is probably can also matters.
Thanks a lot for your references, I'll take a look into them a bit later, since it's already late here.
Statistics: Posted by PerfectDay — Sun Feb 08, 2026 8:41 pm